RESEARCH CONCEPTS RC3000 Manual de usuario descargar pdf (Pagina 116)

RC3000 Antenna Controller Chapter 3 Detailed Operation

108

3.3.1.3 Super-User Access Items

This set of configuration groups allows the user to modify parameters that are not typically changed for a

particular installation. Usually these items address parameters that have been previously characterized

for a particular mount. The need to access these items would typically only occur if a unique

customization of the system was required.

3.3.1.3.1 Reset Defaults

RESET CODE: 0 CONFIG-DEFAULTS

0-NORMAL/1-INSTALL/2-SUPER<5 DIGIT CODE>

The CONFIG-DEFAULTS screen is used to reset the controller's non-volatile memory. When this occurs,

the various CONFIG mode items are initialized to a default value. This operation is usually performed at

the factory. Access to this item is allowed only when the Expert Access flag is set. To reset the system

memory, the user must key in the same 5 digit code used for Expert Access, followed by the ENTER key.

Sections 3.3.1.1, 3.3.1.2 and 3.3.1.3 explain the items covered by the three levels of access: normal,

installation and super-user.

NOTE: the two expert access codes are contained in appendix A. This appendix may have been

removed by a system manager to limit use of the codes.

Besides restoring configuration items to their factory default values, stored satellite data including inclined

orbit tracking tables will be cleared.

Appendix B provides tables of factory defaults for each mount type supported. It is strongly suggested

that the appropriate table be used to record installation specific data should this data somehow become

corrupted in the controller.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 174 175

Sin comentarios

RESEARCH CONCEPTS RC3000 Manual de usuario Pagina 116